This circuit contains three light-emitting diodes arranged in the shape of a triangle. A sparkling display is produced when the circuit is switched on as the l.e.d.s independently flash on and off.
Different versions of this kit are available:
the STANDARD kit contains one l.e.d. of each colour (blue, green, pink),
ALTERNATIVE kits contain three l.e.d.s of a single colour (either all blue, all green,
all pink, all red or all yellow).
Please state "STANDARD" or the COLOUR you require in the "note to seller" box at the checkout.
Watch the circuit working on the Irby Electronics YouTube channel.
When this circuit was tested, a set of Duracell Plus Power batteries was still producing a good light output after 400 hours of continuous use.
The circuit is made on track board (approx. 6 cm x 2 cm) and requires 2 x AA batteries (not supplied). Soldering is ESSENTIAL for this kit.
These tools are needed to make this kit (not supplied):
small pliers for bending component leads,
small wire cutters for cutting component leads and link wire,
small, low power soldering iron, e.g. 15 watt, 18 watt or 25 watt.
Please read the safety warning in the About Irby Electronics section before ordering a kit.
Shipping & delivery
This item will be posted to you by Irby Electronics within 3 days of receiving payment.
|Shipping destination||Cost||Additional items|
You have 14 days, from receipt, to notify the seller if you wish to cancel your order or exchange an item.
Unless faulty, the following types of items are non-refundable: items that are personalised, bespoke or made-to-order to your specific requirements; items which deteriorate quickly (e.g. food), personal items sold with a hygiene seal (cosmetics, underwear) in instances where the seal is broken.