View shop
Add to basket
Item details
Shipping & delivery
This item will be posted to you by Irby Electronics within 3 days of receiving payment.
| Shipping destination | Cost | Additional items |
|---|---|---|
| United Kingdom | £2.90 | £1.50 |
| Europe | Doesn't deliver here | |
| United States | Doesn't deliver here | |
| Rest of the World | Doesn't deliver here | |
You have 14 days, from receipt, to notify the seller if you wish to cancel your order or exchange an item.
Unless faulty, the following types of items are non-refundable: items that are personalised, bespoke or made-to-order to your specific requirements; items which deteriorate quickly (e.g. food), personal items sold with a hygiene seal (cosmetics, underwear) in instances where the seal is broken; digital items.
Please note that if your order is being posted outside mainland UK, you (or the recipient) may have to pay customs or VAT charges and a handling fee. The seller is not responsible for any charges or fees that may incur.
Full description
This kit contains ten light-emitting diodes arranged in a circle. When switched on, the l.e.d.s flash on and off, independently, to make a sparkling display.
Different versions of the "Circle of Light" kit are available. Please choose the colour of the ten l.e.d.s you would like in your kit. Choose either two l.e.d.s of each colour (blue, green, pink, red and yellow) or choose ten l.e.d.s of a single colour (either all blue, all green, all pink, all red or all yellow).
Please have a look at a working version of the "Circle of Light" circuit on the Irby Electronics YouTube channel.
When this circuit was tested, a set of Duracell Plus Power batteries was still producing a good light output after 40 hours of continuous use.
The circuit is made on foam board (approx. 14 cm x 10 cm) and requires 2 x AA batteries (not supplied). The joints in the circuit can be made by simply twisting wires together and then crimping the connection with pliers. Soldering, however, makes a better electrical joint.
These tools are needed to make this kit (not supplied):
small pliers for bending component leads,
small wire cutters for cutting link wire,
slotted screwdriver for securing foam board to wooden base,
small, low power soldering iron, e.g. 15 watt, 18 watt or 25 watt (only if soldering is to be attempted).
Please read the safety warning in the About Irby Electronics section before ordering a kit.
Designed by John Doyle in Irby, Wirral
Other shop items you might like:
More items from this category