Full description

PLEASE DON'T FORGET TO READ THE SIZE GUIDE

This listing is for a PERSONALISED, ENGRAVED handmade bike chain link, paracord bracelet.

Handmade from high quality 2mm paracord, wound around a bike chain link, flanked by two stainless steel spacer beads and finished with a stainless steel sliding magnetic clasp.

This bracelet can be personalised with up to 16 letters/numbers engraved onto the chain link. Please add your requirements within the personalised section below.

Choose from 12 different colour designs.

The colour choice can be seen in the LAST PHOTOGRAPH within the listing.

Sizing Guide

To find your bracelet size, please follow these steps:

STEP 1: Measure your wrist with thin flexible tape, a strip of paper or thin length of cord, just below the wrist bone, where you would normally wear the bracelet. The tape should be FIRM around the wrist but not too tight.

STEP 2: If you're using a strip of paper or cord, mark your size with a pen or pencil then use a ruler to measure the length. That would be your WRIST SIZE.

STEP 3: To find your BRACELET SIZE, just add your wrist size with the appropriate measurements below.

FITTING GUIDE, ADD cm(s) TO WRIST SIZE

Comfort Fit. Add 1.5cm

Loose Fit Add 2cm

For example, if you have a 19cm wrist and require a comfort fit, you should choose a bracelet size of 20.5cm from the menu.