View shop
Feet for Slate Frames - Set of 4 feet -designed for my frames but can be adapted
£29.50
96 Available
Add to basket
Item details
Shipping & delivery
This item will be posted to you by West Pennine Workshop within 7 days of receiving payment.
| Shipping destination | Cost | Additional items |
|---|---|---|
| United Kingdom | £4.65 | |
| Europe | Doesn't deliver here | |
| United States | £13.50 | £1.50 |
| Rest of the World | £13.50 | £1.50 |
All items are hand made to order, very little is kept in stock, so please allow me a few days to make your items. I will keep you informed of progress and if you would like photos of your items being made, just ask.
You have 14 days, from receipt, to notify the seller if you wish to cancel your order or exchange an item.
Unless faulty, the following types of items are non-refundable: items that are personalised, bespoke or made-to-order to your specific requirements; items which deteriorate quickly (e.g. food), personal items sold with a hygiene seal (cosmetics, underwear) in instances where the seal is broken; digital items.
Please note that if your order is being posted outside mainland UK, you (or the recipient) may have to pay customs or VAT charges and a handling fee. The seller is not responsible for any charges or fees that may incur.
Full description
Large slate frames are best used with trestles to hold them (see my other listings) but the smaller frames can be held by hand or on a table. If you are holding the frame by hand you may want to put the frame down on a table after you have finished and a set of table feet helps you keep your precious work away from the table surface, clean and safe!
Alternatively, you may prefer to rest the frame on a table using a set of feet and the feet lift your work away from the surface giving you room to work.
Available in 2 sizes -
10cm (4") - perfect for resting your work on a table when not in use
15cm (6") - a bit taller and better if you are planning on working on your embroidery tapestry whilst the frame is standing on the feet
And two shapes - a graceful taper or an hourglass shape.
The hourglass design is 25mm (1") in diameter at the top, 15mm (58") at the narrow point and 25mm at the base, the tapered design goes from 25mm at the top to 15mm at the base.
All the feet are made from Beech, the traditional choice for slate frames but any order can be customised, just send me a message.
Made to order, normally within just a couple of days, they come complete with a M4 threaded insert and a matching 4mm wing screw. Pass the wing screw through one of the existing holes in each corner of my slate frame and attach the feet underneath by screwing into the threaded insert.
Posted by Royal Mail in UK and worldwide
Designed by Ian Mostyn in Ramsbottom
Other shop items you might like:
More items from this category