Articulated Octopus, Flexi 3D Printed Poseable Ocean Figure

An octopus printed in linked segments, so each arm curls and coils independently and stays where you leave it. Printed in one piece with nothing to assemble. Handmade to order on the Isle of Wight. Because every arm poses separately, it never looks the same twice. It will grip a monitor edge, sit on a shelf with the arms spread, or curl into a ball on a desk. Good for an ocean themed room and very good as something to fidget with. Size Dimensions are not currently listed for this piece. Please message before ordering if you need exact measurements and they will be taken from the actual model. Material 3D printed in tough PLA, a rigid plastic. What you receive ONE articulated octopus. Where the photographs show more than one, that is to illustrate the poses and the colour options. Anything else shown is not included. Colour Made to order in the colour you choose. Please message before ordering with what you want so it can be confirmed before printing. Please note Each piece is printed individually to order rather than moulded, so you may see faint layer lines or small variations in the finish. The arm tips are the thinnest part, so uncurl them gently rather than pulling. This has not been tested or certified as a childrens toy and is not sold as one, it is not suitable for children under three, and it should not be given to young children unsupervised. It is not waterproof, so keep it out of water and aquariums, and away from strong heat and direct sunlight. Made to order by 3D Printz IOW on the Isle of Wight.