T Rex Skull on Plinth, 3D Printed Dinosaur Fossil Display Model

A Tyrannosaurus rex skull with the jaw open, raised on a post above a stepped plinth with an engraved nameplate, finished in a pale bone tone. A museum style display piece rather than a toy dinosaur. Handmade to order on the Isle of Wight. The teeth, the eye sockets and the openings through the side of the skull are all printed as part of the form, and the hand finishing brings out the depth in them. Raising the skull on a post rather than resting it flat is what gives it the specimen look. It suits a study, a home office, a classroom, a dinosaur themed bedroom or anywhere a small talking point is wanted. Size Dimensions are not currently listed for this piece. Please message before ordering if you need exact measurements and they will be taken from the actual model. Material 3D printed in tough PLA, a rigid plastic suited to dry indoor use, then hand finished. What you receive One skull, post and plinth as a single display piece. Anything else shown in the photographs is not included. Colour Shown in a bone tone. Made to order in the colour or effect finish you choose, from natural fossil shades to darker aged effects. Please message before ordering so the finish can be confirmed before printing. Please note Each piece is printed individually to order rather than moulded, so you may see faint layer lines or small variations in the finish, and the hand finishing means no two are identical. The teeth and the jaw are fine, so lift the piece by the plinth and dust it with a soft dry brush. Keep away from strong heat and direct sunlight. This is a decorative display model, not a toy, and it is not suitable for children under three. Made to order by 3D Printz IOW on the Isle of Wight.